Traulsen G11010 Dealer's Choice Single Section Reach-In Refrigerator
Tauira: G11010
Kupu Whakataki
This manual provides essential information for the safe and efficient operation, installation, and maintenance of your Traulsen G11010 Dealer's Choice Single Section Reach-In Refrigerator. This unit is a self-contained display refrigerator with a full-height glass door, designed for commercial food service applications. It features microprocessor control, stainless steel exterior, anodized aluminum interior, and epoxy-coated shelves.
Please read this manual thoroughly before installing or operating the unit. Keep this manual for future reference.
Nga korero haumaru
Always observe basic safety precautions when using electrical appliances to reduce the risk of fire, electrical shock, and injury to persons.
- Me whakarite kia tika te turanga o te waahanga.
- Kaua e whakahaeretia te waeine me te taura pakaru, te mono ranei.
- Do not allow children to play on or in the refrigerator.
- Momotuhia te hiko i mua i te mahi tiaki, horoi ranei.
- Tukuna nga ratonga katoa ki nga kaimahi ratonga whai tohu.
Tatūnga
Te wetewete
Carefully remove all packaging materials. Inspect the unit for any shipping damage. Report any damage to the carrier immediately.
Whakanoho
Position the refrigerator on a level, sturdy surface capable of supporting its weight (approximately 395 pounds). Ensure adequate ventilation around the unit. Maintain a minimum of 6 inches of clearance from walls or other equipment for proper airflow to the condenser. Avoid placing the unit in direct sunlight or near heat-generating appliances.
The unit is equipped with 6-inch high casters for mobility. Ensure casters are locked once the unit is in its final position to prevent accidental movement.
Hononga hiko
The Traulsen G11010 operates on 115V/60Hz/1ph power, drawing 7.4 amps. It is equipped with a NEMA 5-15P plug. Connect the unit to a dedicated, properly grounded electrical outlet. Do not use extension cords or adapter plugs.
Nga Tohutohu Whakahaere
Whakaoho Tuatahi
After connecting to power, allow the unit to run for at least 2-4 hours empty to reach the desired operating temperature before loading with products.
Mana Microprocessor
The refrigerator is equipped with a microprocessor control system for precise temperature management. Refer to the control panel for current temperature display and adjustment options. Consult the separate microprocessor control guide for detailed programming instructions, including setting temperature set points, defrost cycles, and alarms.
Uta ana i te pouaka pouaka
Distribute products evenly on the three factory-installed epoxy-coated shelves. Do not block the internal air circulation vents. Overloading the unit or blocking airflow can impair cooling performance.
Maama o roto
The unit features internal lighting to illuminate the contents. The light switch is typically located near the control panel or inside the cabinet. Turn off lights when not needed to conserve energy.
Te tiaki
Ko te tiaki i nga wa katoa ka tino pai te mahi me te whakaroa i te oranga o to pouaka pouaka.
Te horoi
- roto: Clean the interior regularly with a mild soap and water solution. Rinse thoroughly and dry. Do not use abrasive cleaners or steel wool.
- Waho: Wipe down the stainless steel front and anodized aluminum sides with a soft cloth and a non-abrasive cleaner. For the glass door, use a standard glass cleaner.
- Pūkete: Inspect door gaskets for tears or damage. Clean gaskets regularly with warm, soapy water to maintain a proper seal.
Whakapai i te Coil Condenser
The condenser coil should be cleaned every 30-90 days, depending on the operating environment. A dirty condenser coil reduces efficiency and can lead to compressor failure. Disconnect power before cleaning. Use a stiff brush or vacuum cleaner to remove dust and debris from the coil fins.
Raparongoā
| Raruraru | Take pea | Rongoā |
|---|---|---|
| Ko te waeine kaore i te whakamatao | No power; Dirty condenser coil; Door not sealing properly; Thermostat set too high. | Check power supply; Clean condenser coil; Inspect and clean door gasket; Adjust thermostat setting. |
| Haruru nui | Loose components; Fan motor issue; Unit not level. | Check for loose parts; Contact service technician; Level the unit. |
| Te wai i runga i te papa | Clogged drain line; Drain pan overflowing. | Clear drain line; Check drain pan for proper positioning. |
For issues not listed or if solutions do not resolve the problem, contact a qualified service technician.
Whakatakotoranga
Image: Traulsen G11010 Single Section Reach-In Refrigerator with its full-height glass door open, revealing three epoxy-coated shelves inside. The unit is on casters.
| Āhuahira | Taipitopito |
|---|---|
| Tauira | G11010 |
| Te kaha | 24.2 cu. ft. |
| Nga Ahinga (D x W x H) | 35"D x 29.88"W x 83.25"H |
| Taumaha | 395 Pauna |
| Hiko | 115V/60Hz/1ph, 7.4 Amps, NEMA 5-15P |
| Whata | (3) Epoxy Coated, Factory Installed |
| Momo tatau | Full-Height Glass Door (Hinged Right) |
| Rauemi o waho | Kowiri tira mua, taha konumohe kua whakakikoruatia |
| Rauemi o roto | Konumohe Anodized |
| Ko nga Kaipara | 6" High Casters |
| Kōpeke | 1 / 3 HP |
| Tiwhikete | cULus, NSF |
Pūtāhui me te Tautoko
The Traulsen G11010 comes with a standard warranty:
- Service/Labor: 3 tau
- Kōpeke: 5 tau
For warranty claims, technical support, or to locate authorized service providers, please contact Traulsen customer service. Refer to your purchase documentation for specific contact details or visit the official Traulsen webpae.
