iRobot Roomba Left Side Wheel Module Instruction Manual

Ka mutu te huaview

This document provides instructions for the iRobot Roomba Left Side Wheel Module, an original replacement part designed to restore optimal navigation and cleaning performance to your iRobot Roomba vacuum cleaner.

This genuine iRobot replacement wheel module is compatible with a wide range of iRobot Roomba models, ensuring a perfect fit and reliable operation.

Hototahi

The iRobot Roomba Left Side Wheel Module is compatible with the following iRobot Roomba series and models:

• iRobot Roomba 500 Series: 510, 520, 521, 530, 531, 532, 534, 535, 545, 550, 552, 555, 560, 562, 564, 570, 571, 572 Pet, 580, 581, 585, 595 Pet, etc.
• iRobot Roomba 600 Series: 610, 615, 620, 630, 650, 651, 660, 661, 655, 680, 681, 685, 686 PET, etc.
• iRobot Roomba 700 Series: 760, 770, 780, 790, 765, 775, 776, 782, 772, 786, 785, 790, etc.
• iRobot Roomba 800 Series: 866, 870, 871, 880, 885, 888, 890, 895, etc.
• iRobot Roomba 900 Series: 960, 966, 980, 985, 986, etc.

If your device is not listed, please contact iRobot customer support for compatibility verification.

Tatūnga me te Tāuta

This section outlines the steps for safely replacing the left side wheel module on your iRobot Roomba.

Utauta e hiahiatia ana:

• Wiwiri mahunga Phillips iti

Hipanga Tāuta:

1. Power Off Roomba: Ensure your Roomba is powered off and disconnected from its charging base.
2. Remove Battery (if applicable): For some models, it may be necessary to remove the battery for safety and easier access. Refer to your Roomba's specific user manual for battery removal instructions.
3. Locate Wheel Module: Turn your Roomba upside down. Identify the left wheel module.
4. Tango Tiu: Using a Phillips head screwdriver, carefully remove the screws securing the existing left wheel module to the Roomba chassis. There are typically 2-3 screws.
5. Detach Old Module: Gently pull the old wheel module away from the Roomba. It may be connected by a small wire harness; carefully disconnect it if present.
6. Connect New Module: If there is a wire harness, connect it to the new wheel module. Ensure the connection is secure.
7. Position New Module: Place the new iRobot Roomba Left Side Wheel Module into its designated slot.
8. Haumaru me nga Tiu: Reinsert and tighten the screws to secure the new module firmly in place. Do not overtighten.
9. Reinstall Battery (if applicable): Reinstall the battery if it was removed.
10. Hiko me te Whakamatau: Turn your Roomba back on and perform a test run to ensure the new wheel module functions correctly.

Nga Whakaaro Whakahaere

Once the new wheel module is installed, your Roomba should operate as intended. The wheel module is a critical component for navigation and movement.

• Me whakarite ka huri noa te wira me te kore e arai.
• Listen for any unusual noises during operation, which might indicate an issue with installation or debris.
• Observe Roomba's movement patterns to confirm proper navigation.

Te tiaki

Regular maintenance of your Roomba's wheel modules can extend their lifespan and ensure consistent performance.

• Clean Wheels Regularly: Periodically remove hair, dust, and debris that may accumulate around the wheel axles and treads. This can be done using a small brush or a pair of tweezers.
• Tirohia mo nga aukati: Ensure nothing is lodged in the wheel well that could impede movement.
• Tirotiro mo te kakahu: Over time, the wheel treads may wear down. If you notice significant wear or reduced traction, consider replacing the module.

Raparongoā

If your Roomba exhibits issues after replacing the wheel module, consider the following troubleshooting steps:

• "Error 1 Left" or Similar Error: This error typically indicates an issue with the left wheel.
  • Ensure the wheel module is securely installed and all screws are tightened.
  • Check for any debris or hair obstructing the wheel's movement.
  • Verify that the wire harness (if present) is correctly connected.
  • Perform a Roomba reset (refer to your Roomba's user manual for specific instructions).
• Roomba Moves Unevenly or in Circles:
  • Inspect both left and right wheel modules for obstructions or damage.
  • Ensure both wheels are spinning freely.
  • Clean the wheel sensors (if applicable) on the underside of the Roomba.
• Haruru rerekee:
  • Tirohia mo nga wiri, nga waahanga ranei.
  • Ensure no foreign objects are caught in the wheel mechanism.

If problems persist, contact iRobot customer support for further assistance.

Whakatakotoranga

Pūtāhui me te Tautoko

For detailed warranty information regarding your iRobot Roomba Left Side Wheel Module, please refer to the official iRobot website or the warranty documentation included with your original Roomba purchase.

For technical support, troubleshooting assistance beyond this manual, or to inquire about additional replacement parts, please contact iRobot customer support directly. Contact information can typically be found on the iRobot official website or in your Roomba's original user manual.