Ka mutu te huaview
The DIRECTV RC73 IR/RF Remote Control is designed for seamless control of your DIRECTV Genie system and other compatible devices. It features both Infrared (IR) and Radio Frequency (RF) technologies, allowing for flexible operation without needing to point the remote directly at the receiver when in RF mode. This remote offers a streamlined layout with essential buttons for navigating your entertainment.
Image: Two DIRECTV RC73 remote controls, showcasing their black and white design and button layout.
Tatūnga
1. Tāuta Pūhiko
Your DIRECTV RC73 remote control requires two AA batteries for operation. These batteries are typically included with your purchase.
- Kimihia te uhi o te wahanga pākahiko kei muri o te mana mamao.
- Slide the cover downwards or press the release tab (if present) and lift the cover off.
- Whakauruhia kia rua ngā pākahiko AA, me te whakarite kia tika te tūnga o ngā pito pai (+) me te pito kino (-) ki ngā tohu i roto i te wāhanga.
- Whakahokia te taupoki o te wāhanga pākahiko, ka nekehia anō ki tōna tūranga kia pāorooro rawa.
Image: Two DIRECTV RC73 remote controls shown with two AA batteries and a small instruction guide, illustrating the contents of the package.
2. Pairing the Remote to Your DIRECTV Genie Receiver (RF Mode)
To enable RF (Radio Frequency) control, allowing you to operate your receiver without direct line-of-sight, follow these steps:
- Point the remote at your DIRECTV receiver.
- I te wa kotahi ka pehi me te pupuri i te wahangu pātene me te KORERO button on the remote for approximately 5 seconds.
- Release the buttons when the green light on the remote blinks twice.
- Using the number pad on the remote, enter the code 961.
- Pehia te TE WHAKARANGA kotahi te paatene.
- Pehia te KAUPAPA button (located below the number pad).
- Observe your TV screen. A message should appear indicating "Applying RF/IR Setup. Please Wait..." followed by "Your Remote is now setup for RF."
- Pehia te KORERO (OK) button on the remote to confirm.
3. Programming the Remote to Your TV (Volume Control)
To control your TV's volume and power with the RC73 remote, you need to program it to your television. This process typically involves selecting your TV's brand from the receiver's menu.
- Pehia te MENU button on your DIRECTV remote.
- Navigate down using the WANANGI Raro button to find and select Tautuhinga.
- Once in Settings, use the directional arrows to navigate to the right until you find and select Mana Mamao.
- From the Remote Control Setup menu, select Pair / Paetukutuku Mamao.
- Kōwhiri Program Audio Device.
- You will be prompted to select your TV's brand. Use the keypad or navigate through the list to find your brand (e.g., Samsung). If you don't know the specific model, select "I don't know my model" if available.
- Follow the on-screen prompts to test the code. This usually involves pressing the MANA button on the remote to see if your TV turns off.
- If the TV turns off, select "It Worked" to confirm the programming. If not, select "Try Next Code" and repeat the test until a working code is found.
Nga Tohutohu Whakahaere
The DIRECTV RC73 remote control features a user-friendly layout for intuitive navigation and control of your DIRECTV system and connected devices.
Image: A detailed diagram of the RC73 remote, illustrating the function of each button for comprehensive control.
| Pātene | Mahi |
|---|---|
| ON/OFF (RC73) | Turns both DIRECTV Receiver and TV ON or OFF at the same time. (Remote must be programmed for TV; HD DVR still records when off.) |
| ARIKI | Press once for On-Screen Guide. Press twice for programming grouped into categories. |
| MENU | Accesses the main menu for settings, recordings, and more. |
| RĀRANGI | Displays the LIST of your recorded programs. |
| Waiho | Exits the current menu and returns to the previous channel viewed. |
| KORERO | Selects the item highlighted on screen. |
| INFO | Displays INFORMATION about the program now playing or highlighted in the On-Screen Guide. |
| VOL (Rōrahi) | Adjusts the volume of your TV or audio device (if programmed). |
| CH (Hongere) | Ka huri i te hongere ki runga, ki raro ranei. |
| Tuhinga o mua | Returns to the PREVIOUS channel viewed. |
| RECORD (Red Circle) | Records the program now playing or highlighted in the On-Screen Guide. Press twice to record the entire series. |
| wahangu | Wahangu ana te tangi. |
| TANGATA | Replays the previous six seconds. |
| WHAKAARO | Rewinds at increasing speeds—press up to four times. |
| TAKARO/PAUSE | Plays the current program. Press once while the program is playing to PAUSE. |
| DASH (-) | Press for Guide Options while viewing On-Screen Guide. Press for playlist options while viewing playlist. Press to display last 6 digits of receiver ID, satellite signal type (SWiM or Multiswitch) and Internet status. |
| WHAKAHUI | Advances 30 seconds. Press and hold to jump ahead to the end of a recorded program. |
| KAUPAPA KAUPAPA | Fast-forwards at increasing speeds—press up to four times. |
| ENTER (Input) | Press for Mini Guide while viewing your program and dismiss with EXIT. ENTER also replaces TV INPUT button: to cycle through the equipment connected to your TV, press and hold for three seconds until LED light at top turns green. Then scroll through inputs by pressing ENTER again. |
Te tiaki
Whakakapinga Pūhiko
When the remote's performance degrades or the green light no longer blinks during operation, it's time to replace the batteries. Always use two new AA batteries for optimal performance.
- Remove the battery compartment cover as described in the Setup section.
- Tangohia nga pākahiko tawhito.
- Insert two new AA batteries, observing the correct polarity (+/-).
- Whakakapia te uhi o te wahanga pākahiko.
Te horoi
To maintain the remote's appearance and functionality, periodically wipe it with a soft, dry cloth. Avoid using abrasive cleaners, solvents, or harsh chemicals, as these can damage the remote's surface or internal components.
Raparongoā
| Putanga | Take pea | Rongoā |
|---|---|---|
| Kāore te mamao e aro atu ki te kaiwhiwhi. | Low or dead batteries; Remote not paired in RF mode; Obstruction between remote and receiver (if in IR mode). | Replace batteries. Ensure remote is paired in RF mode (refer to Setup section). Remove any obstructions. |
| Volume or TV power buttons not working. | Remote not programmed to TV. | Program the remote to your TV (refer to Setup section, "Programming the Remote to Your TV"). |
| Green light on remote blinks slowly or not at all. | He iti te mana pākahiko. | Whakakapia tonu nga pākahiko. |
| Remote controls receiver but not client device (e.g., Genie Mini). | Client device not properly paired or connected. | Ensure the client device is correctly connected and powered on. Re-pair the remote with the client device if necessary (consult your Genie Mini's specific instructions). |
Whakatakotoranga
- Waitohu: DIRECTV
- Tauira: RC73
- Tauira Tūemi: 4336303112
- Hangarau Hononga: Infrared (IR), Radio Frequency (RF)
- Ngā Pūrere Hototahi: DIRECTV Genie (HR44 or above), Genie Lite (H44 or above), Genie Mini (C41 or above), 4K Genie Mini (C61K or above), Wireless Genie Mini (C41W or above) in RF mode. All DIRECTV receivers and DIRECTV Ready TVs in IR mode.
- Puna Hiko: 2 pākahiko AA (kei roto)
- Taumaha Tūemi: 1 hekere
- Ahu mōkihi: 9.61 x 3.7 x 2.91 inihi
- Tae: Pango
- Āhuahira Motuhake: Original DirecTV Equipment
Pūtāhui me te Tautoko
For specific warranty information regarding your DIRECTV RC73 remote control, please refer to the documentation included with your original purchase or visit the official DIRECTV webpae. He rereke nga tikanga me nga tikanga whakamana.
For technical support, troubleshooting assistance beyond this manual, or to inquire about replacement parts, please contact DIRECTV customer service directly. Contact information can typically be found on your DIRECTV bill, their official website, or through your service provider.
Rauemi ipurangi:
- Official DIRECTV Webpae: www.directv.com
- Support Pages: Look for a "Support" or "Help" section on the DIRECTV website for FAQs and additional guides.
Tuhinga e pa ana - RC73, 4336303112
 |
Aratohu Mana Mamao a DIRECTV Genie me te Ao Whānui He aratohu whānui hei mārama ki ngā mahi a ngā mana mamao DIRECTV Genie me Universal, tae atu ki ngā whakamārama taipitopito mō ngā pātene me ngā tohutohu hōtaka mō ngā momo kaiwhiwhi me ngā pouaka whakaata DIRECTV. |
 |
Aratohu Mana Mamao Ao Whānui a DIRECTV: Te Tīmatanga me te Hōtaka Akohia me pēhea te whakamahi i tō mana mamao whānui DIRECTV, te mārama ki ngā mahi pātene, me te hōtaka i tō mana mamao RC73 mō ngā pūkete pakihi. Kei roto ko ngā tohutohu me ngā āhuatanga whakarite. |
 |
DIRECTV Wireless Genie Mini Tatūnga me te Aratohu Whakahohe Ko nga tohutohu taahiraa-i-taahiraa mo te hono, te whakarite, te whakahohe, me te whakarite i to DIRECTV Wireless Genie Mini hou mo te whakangahau ataata kore. |
 |
Ngā Tohutohu Whakahohe Tūmau DIRECTV Genie 2 me te Whakahoki Taputapu He aratohu taahiraa-i-te-taahiraa mō te whakahohe i tō Tūmau DIRECTV Genie 2 whakakapinga me te whakahoki i ō taputapu tawhito kia kore ai e utua he utu kore whakahoki. Kei roto ko ngā tikanga whakatū, te hono, me te whakahoki. |
 |
Pukapuka ā-ringa mō te hua o te DIRECTV Genie 2 - Ngā āhuatanga, ngā whakaritenga, me ngā mōhiohio haumaru He pukapuka ā-ringa whānui mō te kaiwhiwhi amiorangi DIRECTV Genie 2, e kapi ana i ngā taipitopito taputapu, ngā āhuatanga, te rapurongoā, ngā tohu LED, ngā whakatūpato haumaru, me ngā mōhiohio pūtāhui. Kei roto ko ngā aratohu tatūnga me te whakahaere. |
 |
Aratohu Tāutanga DIRECTV Ahokore Genie Mini C41W He aratohu taahiraa-i-te-taahiraa mō te tāuta me te hono i te DIRECTV Wireless Genie Mini (Tauira C41W) ki tō Genie HD DVR hei whakapai ake i te whakangahau kāinga. |